Electrician in Veneta and Elmira, Oregon

How power gets to a barn or shop

A barn or shop usually gets its power from a buried wire that runs from the house panel to a small panel inside the building. The wire is sized for how far it travels and for what you'll run at the far end, so tell us about the welder, the compressor, or the heater before we price it. A run of a few hundred feet needs a heavier wire than one across the driveway. Inside, we lay out lights and outlets around the workbench and the doors. Our shop and barn wiring page goes into more detail.

If you're planning an RV pad or a gate opener out by the road, mention it while we price the barn, since one trench can often carry both.

Wells and pump houses

When a well pump trips its breaker or stops starting, the whole house is out of water. We troubleshoot the electrical side, from the panel to the pressure switch, and work with your pump contractor when the pump itself needs replacing. See well pump electrical.

Homes in town

Inside Veneta, the houses run newer than in Eugene or Springfield. About a third of the city's 2,099 homes were built before 1980, according to the Census Bureau's American Community Survey. Newer houses tend to have panel space for an EV charger or a hot tub.

EPUD and Lane Electric

EPUD serves Veneta and Elmira, and Lane Electric's territory starts at the eastern edge of the city, so part of Veneta is on Lane Electric. The utility named on your bill decides which programs apply; the Emerald PUD guide and the Lane Electric guide list each one's offers. EPUD crews had Jeans Road in Veneta back on by January 18, 2024 during the ice storm, KATU reported. With a generator hookup on the pump circuit, a portable generator keeps the water on through a wait like that.

The City of Veneta contracts with the City of Cottage Grove for electrical permits, so Cottage Grove's electrical inspector covers work inside Veneta, while Elmira and the land outside city limits go through the Lane County Building Program.